How wide is too wide for grout?

How wide is too wide for grout?

As a general rule do not go larger than 3/16″ although under certain circumstances such as some slates and quarry tiles, 1/4″ is acceptable. If you choose to use smaller grout lines you must ensure the tile will allow it. If you don’t you may end up with lines that “jog”.

How wide should grout joints be?

TCNA recommends a minimum 1/8″ grout joint for rectified tile and minimum 3/16″ grout joint for calibrated tile. They also suggest adding to this width the amount of edge warping on the longest edge. For example, if the edge warping of a rectified tile is 1/32″, the minimum grout joint is 1/8″ + 1/32″ = 5/32″.

Are larger grout lines better?

The wider the grout line, the more noticeable it will be when your installation is complete. It may also require a little more attention during cleaning. Make sure that your grout lines accent and highlight the beauty of your flooring, rather than distract from it.

Should grout lines be flush with tile?

You want it close to being flush with the tile edges; otherwise, you’ll be able to both see and feel the corners of your tile when you walk over it. A higher-level of grout is also much easier to keep clean than grout lines that fall halfway down the tile.

How wide is a typical grout line?

Grout lines need to be at least 1/16” for the grout to even fit, and often larger than that depending on a variety of other factors. For some grouts, like sanded cement grout, 1/8” is the minimum line size.

How wide should grout lines be in shower?

Regular-format tiles (up to 16-by-16 inches square) call for grout lines 1/8 inch wide for floors. Large-format tiles, 18-by-18 inches wide, require a smaller grout line (1/32 inch). In general, don’t create grout lines larger than 3/16 inch, though slate and quarry tiles can work with as much as a 1/4-inch grout line.

How do you tight grout joints?

10 steps for grouting narrow grout lines

1. Mix the grout. Pour unsanded tile grout into a bucket and mix it with water, carefully following the instructions on the package.
2. Let the grout rest.
3. Scoop.
4. Spread.
5. Force the grout into the grout lines.
6. Scrape off excess.
7. Apply more grout.
8. Let the grout rest.

Can you put grout over grout?

ANSWER – It is possible to grout over existing grout if there is enough depth to do so. 1/8 inch depth may or may not be adequate depending on the type of grout used. A latex modified grout may work, but you have to properly clean the existing grout to ensure the new grout adequately bonds.

How do I know what size grout line to use?

As a general rule, floor tiles should have grout lines of 1/8 inch or larger, depending on the type and size of tile. Special types, such as slate or quarry tiles, often do not have edges uniform enough to work with tight spacing. These tiles usually are spaced with grout lines 3/16 inch or wider.

How do you reduce grout lines?