What is the valet program button Viper?

What is the valet program button Viper?

The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode. 1.

How do I program my Viper remote 7145v?

What I did is:

1. Open the door;
2. Turn the key to ON;
3. Within a short time, press and release the Valet/program button for exactly 7 times;
4. Then press the Valet/program button one more, and hold it.
5. While holding the Valet/program button, press the lock botton of the remote one time.
6. Release the Valet/program button.

How do I program my Viper 474V 4 button remote?

Programming the Viper 474V follows the same procedure as programming any other DEI remote.

1. Open your driver’s side door and get into the vehicle.
2. Push the “Valet” button on the remote one time to program your alarm, two times to program the trunk release and door locks, and three times to program the remote starter.

How do I know if my car is in valet mode?

1. Hold down the brake.
2. Cycle the vehicle key in the ignition between the ‘On’ and ‘Off’ positions 5 times.
3. Do not touch anything on the remote.
4. You will know that you have entered valet mode if you see the parking lights flash one time and/or you hear a faint click from within the dash.

How do I program my automated keyless remote?

If your system uses channel 2:

1. Open the driver door.
2. Insert key in ignition cylinder and turn to your ON/RUN position.
3. Press the valet button TWICE, press again and hold it until step Five. The system will chirp once.
4. Press button #2 on the remote. One chirp confirms channel has been learned.
5. Release the valet button.

What is Viper 488v car alarm?

Viper is a well-known manufacturer of car alarms, keyless entry devices and remote starters. The Viper 488V car protection system has all three capabilities, and you can program your Viper 488V remote in just minutes from your driver’s seat.

How do I program a 488v remote to a car?

Enter your car with your 488V remote, leave your driver’s door open and insert your ignition key into the ignition. Press the “Valet” button on your remote once to program the alarm, twice to program the locks and three times to program the remote starter.

How do I program the remote to the valet horn?

Press and hold the “Valet” button again after the horn sounds, and then press the button on the remote that you would like to program. Do this while still holding the “Valet” button.