What is P0344 engine code?
Diagnostic trouble code (DTC) P0344 stands for “Camshaft Position Sensor “A” Circuit Intermittent (Bank 1 or Single Sensor).” It triggers when the PCM detects a loss of signal from the Bank 1 camshaft position sensor. Bank 1 refers to the bank of the engine that contains cylinder #1.
What does camshaft position sensor a bank 1 circuit malfunction mean?
The OBD-II diagnostic trouble code P0340 indicates a “Camshaft Position Sensor “A” Circuit Malfunction.” It covers the entire circuit attached to the aforementioned sensor, such as the electric wiring and the powertrain control module (PCM). Thus, replacing the sensor will not always resolve the issue.
How much does it cost to replace a camshaft position sensor?
To replace a camshaft position sensor, you can expect to pay anywhere from $95 to $200. Parts alone will run about $25 to $100. Labor costs will be in the range of $70 to $100 for professional replacement.
What is the code for a bad camshaft position sensor?
P0340 is a diagnostic trouble code (DTC) for “Camshaft Position Sensor Circuit Malfunction”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What is P0365 code?
Essentially, the P0365 code means that there has been a lack of voltage detected from the camshaft position sensor B in bank 1 by the PCM within a few seconds of the engine starting.
What is bank1 sensor B?
Bank 1 is the side of your engine that has the cylinder 1, while sensor B refers to the exhaust camshaft side. Some car manufacturers have their own description of the P0017 code, such as GM (more specifically, Chevrolet).
How many camshaft sensors does a 5.7 Hemi have?
Your 5.7L engine has one crankshaft, and 1 camshaft.
What happens when camshaft position sensor goes out?
A failing camshaft position sensor begins losing its ability to quickly transfer data. Mismatched fuel delivery and ignition timing, even if off by a few milliseconds, will cause your vehicle to sputter, accelerate poorly, lack power, stall or even shut off.
How to diagnose the p0344 code on a Dodge Ram?
Here are the steps that a professional mechanic would take to diagnose the P0344 code. Double-check the battery voltage to ensure the signal isn’t weak. Inspect the wiring to the camshaft position sensor. Look for signs of wear or damage, such as melted parts, burnt spots, rubbing or chaffing.
What does p0340 and p0341 mean on a camshaft position sensor?
It’s possible to also see P0340 (Camshaft Position Sensor “A” Circuit) and P0341 (Camshaft Position Sensor “A” Circuit Range/Performance) trouble codes at the same time. While these codes are related to the same parts, they show the length of time the problem has persisted and what electrical issues exist.
How much does it cost to diagnose a p0344 code?
Labor: 1.0 The cost to diagnose the P0344 DODGE code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.