What is chock used for?
Wheel chocks are a wedge of sturdy material, such as polyurethane or rubber, placed against a vehicle’s wheels to prevent accidental movement.
How do you use a motorcycle chock?
How to Use a Motorcycle Wheel Chock
- Mount the Wheel Chock. Mount the wheel chock to the deck of your truck bed or trailer.
- Secure the motorcycle. Secure the motorcycle to the trailer with four tie-down straps – two in the front and two in the back.
- Tighten the straps.
- Put into Gear.
Do you have to bolt down a motorcycle wheel chock?
Pingle, Pop and other basic chocks all require the mounts (not the chock) to be bolted to the floor. The high end strap-less chocks have the same problem. You can’t just let them slide on the floor when you are trucking down the rode.
Do I need a motorcycle wheel chock?
It is strongly advised to avoid tying down a motorcycle without a chock if it can be avoided. Whenever possible, either get a wheel chock or a replacement material. Tying down your bike should accomplish a fine job of preventing movement while you drive around, but a chock is always a prudent safety measure.
Why are chocks called chocks?
What does it mean? What is Chocks on and Chocks Off. Chocks, the word meaning referred with airport and airlines is actually a wedge-shaped sturdy rubber or wooden block or even a metal structure. These pieces of wood or rubber or metal is usually used to stop or prevent the motion of an aeroplane on ground.
How many chocks do I need?
The standard notes that chocks should be placed under the rear wheels, which means two chocks should be used – chocking just one wheel isn’t enough. If operators are chocking both sides of the wheels, then you must have a total of four chocks – two for each side.
What is choke motorcycle?
A choke valve/cable is designed to restrict the flow of air in the carburettor of an engine. This helps enrich the fuel-air mixture, improving the ability to start an engine in low temperature conditions.
How do you strap down a motorcycle without a wheel chock?
Tying Down A Motorcycle Safely
- Apply soft straps to your motorcycle, securing the ends to the sides of your trailer or the fixtures on your truck bed.
- Loop each soft strap to a ratchet strap.
- Then, compress your shocks a bit — this will prevent the straps from disengaging if you drive on a bumpy road.