What frequency should I set my amp to?

What frequency should I set my amp to?

Set the crossover point around 10 Hz below the lowest frequency your speakers can produce without issue. (keep in mind that the most common recommendation for crossover frequency is 80 Hz). Once again, play some music. But this time, slowly turn up your receiver’s volume until you hear it begin to distort.

How should I set my subwoofer amp?

Turn your sub amp’s gain to its lowest, most counter-clockwise position. Switch its low-pass filter on and set it as high, clockwise, as it will go. If it has a bass boost, turn it off.

How many watts can a kicker CVR 12 handle?

The CompVR 12-Inch Subwoofer works best with a sealed or ported enclosure and 400 watts of recommended power. See below for more details.

What amp does two Kicker 12’s need?

A: You need at least a 500 watt amp with one of these speakers more if you have two.

What should LPF be set on AMP?

With only one amp receiving signal from your head unit, play your favorite type of music at about 75% volume with the LPF filter on your amp set as high as it will go. Slowly turn the dial from high to low until you stop hearing all the high frequencies through your subwoofers.

What should LPF be set on amp?

What size amp do I need for 2 12-inch Kicker Comp R?

You will need a 1000 RMS watt amp.

How many watts do you need to power 2 12-inch subs?

Then determine the amount of power your subwoofers can handle. RMS power handling of a 55 series 12” dual 2 ohm voice coil subwoofer is 400 watts. Two of these subwoofers would mean you need 800 watts of power at to the total circuit impedance.

What should I set my LPF and HPF to?

Recommended Starting Points: Front Midrange – Band-Pass Filter = 80 Hz HPF & 5,000 Hz LPF (12 db or 24 db Slope) Rear Speakers (Passive) – High-Pass Filter = 80 Hz (12 db or 24 db Slope)