How do you use the clean function on a Sunbeam iron?

How do you use the clean function on a Sunbeam iron?

Unplug your iron and hold it over a sink with the soleplate facing downwards. Press and hold the self-clean button. Hot water and steam will be ejected from the holes in the soleplate along with any impurities.

How do you clean the inside of a steam iron?

Clean the Inside of the Iron

1. Mix 1/4 cup white vinegar with 3/4 cup distilled water.
2. Plug in the iron and turn the steam feature on.
3. Let the iron heat up for approximately 3 to 5 minutes.
4. Press the steam button and hold until steam comes out.
5. Repeat 4 to 6 times before turning off the iron.

How do you use a Sunbeam steam iron?

USING THE STEAM IRON Set the Steam Iron in an upright position and insert the plug into the wall electrical outlet. Select the desired temperature on the Temperature Control Dial. The Indicator Light will go on and once the selected temperature is reached, the light will go off and you can begin to Iron.

Why is my Sunbeam iron not heating up?

My Iron isn’t heating up. Ensure that the unit is tightly plugged into a working outlet. Some units are equipped with our patented Motion Smart Auto Off technology. Moving the iron will cause it to begin to reheat.

How do you use a Sunbeam steam Master iron?

Setup Process: Fill with water, plug in, set, and go For dry ironing, the initial setup is fairly simple: Just remove the iron from the packaging, plug it in, and turn the Fabric Select Dial, located above the handle, to the desired setting depending on the fabric being ironed.

How do I deep clean my iron?

Mix a half-cup of distilled white vinegar and half-cup of distilled water and pour it into the iron. Inspect the steam vents for white residue or other buildup and use a toothpick or toothbrush dipped in vinegar to clean them out. Plug in the iron, set it for steam, and wait for about five minutes.

Can steam irons be repaired?

The expense of repairing damaged cords or broken handles can often outweigh the cost of the iron. Consider replacing the iron, rather than attempt to repair these parts. Failure to replace the damaged parts with those made specifically for your make and model of steam iron could result in additional damage.

How do you fix an iron that won’t heat up?

1. Make sure that your appliance is plugged into a working outlet.
2. Check the power cable and make sure that it’s not damaged.
3. Make sure the temperature adjustment knob is set above the MIN position.
4. Once you plug in your iron and adjust the temperature, the thermostat indicator should light up.

How do you iron a Sunbeam iron?

For dry ironing, the initial setup is fairly simple: Just remove the iron from the packaging, plug it in, and turn the Fabric Select Dial, located above the handle, to the desired setting depending on the fabric being ironed.