Can you install Windows on RAID 1?

Can you install Windows on RAID 1?

No. You need to plug both drives in, enable the RAID controller via BIOS settings, then format both drives and build an array. Once the array is built, you then install windows and go about your merry way.

How do I install Windows 7 in RAID mode?

FAQ :: How to make RAID 0 array to install Windows 7 64 bit for my A75/A55 chipset motherboard with SATA HDD and SATA DVD ROM?

1. Press [Delete] key in POST screen go to BIOS > Chipset > South Bridge > SB SATA Configuration > OnChip SATA Type, set it to [RAID] mode.
2. Press [F4] key to Save Configuration and reset.

Can you set up RAID 1 after OS install?

If your operating system is already installed, you can use RAID if the following requirements are met: Your system has a RAID I/O controller hub (ICH). If your system does not have a RAID ICH, you cannot use RAID without installing a third-party RAID controller card. Your RAID controller is enabled.

Can I add RAID 1 later?

Yes, you CAN migrate your single drive volume to a 2 drive RAID1 volume at a later point.

Which is better AHCI or RAID?

If you are using a SATA SSD drive, AHCI may be more suitable than RAID. If you are using multiple hard drives, RAID is a better choice than AHCI. If you want to use an SSD plus extra HHDs under RAID mode, it’s recommended that you continue using RAID mode.

How do I install Windows on a RAID drive?

Select the Advanced menu, and then select the Drive Configuration menu. Set the Drive Mode option to Enhanced. Enable Intel® RAID Technology….Follow these steps to install an operating system onto a RAID volume:

1. Enable RAID in system BIOS.
2. Create a RAID volume.
3. Install the RAID driver using the F6 installation method.

Can I create a RAID 1 without losing data?

Re: Create a new RAID 1 with existing hard drive without losing data. It depends. If the dis currently is a RAID0 you can extend to RAID1, if it is a plain disk you need to backup and restore.

Do you setup RAID before installing OS?

However, if you want to install the OS from an OS install disk, you will need to create the RAID volume before installing the OS. For SGX-SAS6-R-REM-Z – You must create a RAID volume before installing an OS on a drive. You must also make the drive bootable.

Can I remove RAID1 without losing data?

You should be able to delete a RAID 1 mirror without losing data if the RAID 1 volume is: The only volume on the array.